Why the bathroom smells even after you clean it
The smell is not coming from the bowl. It comes from the joint underneath it, where the toilet outlet meets the floor flange. That joint is sealed by a ring, and when the seal fails, sewer gas leaks into the room continuously - not only when you flush.
Most homes have a wax ring there. Wax works once. If the toilet is lifted for any reason, if the floor shifts, or if the bowl rocks slightly on a loose bolt, the wax cracks and never re-seals. You end up with a slow, permanent drain smell and sometimes water staining around the base.
What this kit does differently
This is a wax-free flange seal. The flexible ring compresses against the flange and the toilet horn, then springs back, so it keeps sealing through small movement instead of cracking. It can also be lifted and repositioned during installation - a wax ring cannot.
- No wax to crack - the seal stays elastic over time
- Repositionable - you can lift the bowl and set it back down without replacing the ring
- Complete hardware - mounting bolts, nuts, bolt caps, spacer washers and retaining washers are included, so you are not hunting for parts mid-job
What's in the box
- 1 x wax-free toilet flange seal ring
- 2 x mounting bolts with nuts
- 2 x bolt caps
- 2 x spacer washers
- 4 x retaining washers
How to fit it
- Shut off the water supply and flush until the tank is empty. Sponge out what is left so nothing spills when the bowl comes up.
- Disconnect the supply line, undo the floor bolts and lift the toilet straight up. Set it on a towel on its side.
- Scrape the old wax off both the flange and the toilet horn. The surface needs to be clean and flat, or the new seal will sit unevenly.
- Press the new seal onto the flange, narrow end down, and check that it sits centred over the drain opening.
- Lower the bowl straight down onto the seal. Do not slide it.
- Fit the new bolts, add the washers and tighten the nuts evenly, alternating sides. Stop when the base is firm - the porcelain will crack if you over-tighten.
- Reconnect the supply, run a flush and check for weeping at the base. Then apply a thin bead of silicone around the base only if your installation calls for it.
Fitment boundaries - read before ordering
This seal is made for standard residential toilet flanges. Before ordering, measure the outer diameter of your flange and the inner diameter of the drain opening; a flange that is oversized, recessed, or cast-iron with a damaged lip may need an offset or extra-thick seal instead.
It is not designed for RV or cassette toilets, wall-hung toilets, or commercial flushometer installations. If your toilet sits on a raised spacer or the flange is below the finished floor level, check the height clearance first.
Frequently asked
Can I use this on a second-floor bathroom?
Yes. The seal is not floor-specific - what matters is that the flange is sound and the toilet horn sits centred over the opening.
Do I still need to caulk around the base?
Caulking is cosmetic and helps keep spills out from under the base, but it is not what stops the smell. The seal does that. Leave a small gap at the back if your local code requires it.
What if the smell continues after fitting?
Check the flange bolts and the supply connection first. If the smell persists with a good seal, the source is usually elsewhere - a failed wax ring is the most common cause, but a dry trap in an unused fixture or a cracked vent stack produces the same symptom.
Wax-Free Toilet Flange Seal Ring Kit - Odor-Proof Anti-Leak Gasket with Bolts and Caps
No PayPal account needed — pay with any major card via PayPal.